Crystal nVision Lab Reference Bedienungsanleitung PDF herunterladen (Seite 6)

Module Queries and Commands  4

nVision Programming Instructions

Module Queries and Commands  4

Serial Number

SN? ..........The serial number is returned as a six digit number.

Commands

Automatic Shuto Timer

AO!XXXX Set the auto o time for the chassis. (3600 seconds is the max auto o time.)

—

MODULE QUERIES AND COMMANDS

Communication with the module requires you to specically identify the module location. As shown below, this is done by appending a 1, 2, or 3 to the end

of the query.

Queries

Firmware Version

MOD:VER? 1 ... Returns the nVision rmware version of the lower module in the RXXXXXX.XX format.

MOD:VER? 2 ... Returns the nVision rmware version of the upper module in the RXXXXXX.XX format.

MOD:VER? 3 ... Returns the nVision rmware version of the BARO module in the RXXXXXX.XX format.

Full Scale Range

MOD:FR?

Note: This query is not applicable to the RTD100 module. Full scale range for MA20 switch test is “1". Full scale range for BARO is “15".

XXXX = 0 disables Automatic Shuto (always on)

XXXX = seconds:

30 45 60 120 180 240

seconds seconds (1 min) (2 min) (3 min) (4 min)

300 600 900 1200 1800 2700 3600

(5 min) (10 min) (15 min) (20 min) (30 min) (45 min) (1 hr)

These values can be set to anything from 1 to 3600 seconds. However, once connected to CrystalControl

this value will be reset to the closest value shown in the table. For example, sending the command AO!75

instructs the nVision to set the Automatic Shuto time to 1 minute.

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Crystal nVision Lab Reference Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Werkzeug Crystal nVision Lab Reference